This is happens because Windows incorrectly "thinks" that the drive is having problems and needs to be scanned. As you know, if you shut down your computer improperly, Windows will perform a check disk (chkdsk) when you power on it again. This disk is now ready to be used for a new application.If you looking for a way to disable CHKDSK from running at Windows Startup, continue reading this tutorial.
If we go back and look at the disk in Disk Management, it should now show as "Unknown" and "Not Initialized.That means there are no volumes defined on that drive. If you type "list disk" again you will see that the disk that was cleaned now shows that all space on the drive is free.Once you hit Enter, the disk will be erased.
You will not be given a chance to opt out. At the diskpart prompt, type "clean" and hit Enter.If you have selected a drive which contains data that you want to keep and you proceed beyond this point, that data will be erased. Note: Make absolutely certain you have selected the correct disk. At the diskpart prompt, type "select disk x", where x is the disk number that you want to clean.If there were a volume defined on this drive it would likely show zero free space. The free space indicated in diskpart means "space that is available for use on the drive but which does not have a volume defined". Note that disk 5 is the disk we need to clean. This will list all the hard drives in the system. At the diskpart prompt type "list disk".At the prompt, type "diskpart" and hit Enter.Right-click on "Command Prompt" and choose "Run as Administrator". Open the Start menu and go to "Accessories".This is a 3 TB disk with an MBR partition table. Open Disk Management and locate the disk in question.Note: An USB to SATA Adapter is required if not directly connecting the hard drive to a PC's SATA connector. Cleaning a Disk in Windows 7 (or later) Using Diskpart
0 kommentar(er)
